⎝⎛韦德足球⎞⎠

Centrifugal spray drying series

Position: ⎝⎛韦德足球⎞⎠ > Products > Centrifugal Spray Drying Series >

Centrifugal spray dryer


High-speed centrifugal spray dryer, today will give a basic description and introduction of this dryer, and through the following introduction, we can let us know the different types of centrifugal spray dryer, and then increase our expertise in this area.
1.Installation
(1) During the installation of the high-speed centrifugal spray dryer, the floor should be calibrated. Drainage troughs should be left around the machine, and installation should be performed according to the picture requirements.
(2) The power should be connected according to the electrical schematic diagram, and the ground wire must be installed so that the machine can be used safely.
2.Check before starting
(1) Between the heater and the air inlet pipe, and between the air outlet pipe and the drying chamber, and between the air outlet pipe and the cyclone separator, the three connections should be connected and sealed with a sealing ring to Leak-proof.
(2) When installing the ash discharge valve, check the connection between the ash discharge valve and the lower part of the cyclone, whether it is connected, and whether it is clamped.
(3) Whether the fan rotates normally, whether it can run normally, and whether the regulating butterfly valve is open, pay attention not to shut it down.
3.Parking
(1) Turn off the windshield first, then remove the pollinator, then open the windshield, and add fresh water into the feeding cylinder. The outlet temperature should be kept constant to avoid affecting the humidity in the drying room.
(2) After turning off the heater, stop the water supply. Then open the drying room, turn off the fan after taking out the finished product, and finally clean the centrifugal spray head.
七乐彩 韦德足球 欢乐拼三张 欢乐拼三张