⎝⎛韦德足球⎞⎠

Centrifugal spray drying series

Position: ⎝⎛韦德足球⎞⎠ > Products > Centrifugal Spray Drying Series >

Centrifugal spray dryer


In the operation of high-speed centrifugal spray dryer, there are some more important aspects, which are mainly:
(1) Start-up sequence of spray operation
Turn on the power first, then turn on the fan, cooling water pump, and oil pump in order. After that, preheat the drying tower, turn on the spray circulation pump, and check whether the amount of water in the water tank is sufficient and whether the concentration reaches the standard. After the inlet air temperature reaches about 280 ° C, the atomizer can be turned on, and then the inverter is turned on. After the inverter runs to the set frequency, the feed pump is turned on to reach the specified flow rate. Finally, adjust the amount of blanking, open the discharger and start blanking.
(2) Shutdown sequence of spray operation
Turn off the feed pump, the inverter, and the circulation pump in turn. After the temperature of the inlet air drops to about 60 ° C, you can turn off the fan, and finally turn off the cooling water pump and oil pump.
七乐彩 韦德足球 欢乐拼三张 欢乐拼三张